Proposal and Case Studiesof Tapes and Film

「PDMS Microchannels and Microfluidic Devices」Proposal & Case Studies

Search by Category

MOVIE

LaboratoryPDMS Microchannels and Microfluidic Devices

【MOVIE】Creating a Circular Type PDMS Seal
MOVIE

LaboratoryPDMS Microchannels and Microfluidic Devices

【MOVIE】A flexible microfluidic channel chip without leachables at the bonded part
MOVIE

MedicalLaboratoryElectrical and ElectronicLaser ProcessingAssembly and LaminationPDMS Microchannels and Microfluidic Devices

【MOVIE】Microfluidic device with electrodes
MOVIE

LaboratoryPDMS Microchannels and Microfluidic Devices

【MOVIE】Superhydrophilization of PDMS
MOVIE

LaboratoryPDMS Microchannels and Microfluidic Devices

【MOVIE】Example of dispensing reagents (water-soluble ink) into a microchannel
MOVIE

LaboratoryPDMS Microchannels and Microfluidic Devices

【MOVIE】Stretchable microchannel made of transparent EPDM rubber
MOVIE

MedicalLaboratoryLaser ProcessingAssembly and LaminationPDMS Microchannels and Microfluidic Devices

【MOVIE】5 mm channel height PDMS microfluidic channel
MOVIE

LaboratoryPDMS Microchannels and Microfluidic Devices

【MOVIE】PDMS microfluidic channels for creating artificial blood vessel models
MOVIE

MedicalLaboratoryElectrical and ElectronicLaser ProcessingAssembly and LaminationPDMS Microchannels and Microfluidic DevicesPrototypingOthers

【MOVIE】Ultra-thin PDMS Sheet
MedicalLaboratoryPrecision Die-CuttingLaser ProcessingProcessing in the CleanroomCoatingDegassingPDMS Microchannels and Microfluidic Devices

Low-cost, small-batch production of microfluidic channels
MedicalPrecision Die-CuttingProcessing in the CleanroomAssembly and LaminationDegassingPDMS Microchannels and Microfluidic Devices

End-to-end support from microfluidic channel fabrication to packaging
MedicalLaser ProcessingProcessing in the CleanroomAssembly and LaminationDegassingPDMS Microchannels and Microfluidic Devices

Acrylic microfluidic channels available from a single unit

See Behind the Scenes at CSTEC SPECIAL CONTENTS

A customer's request is partial welding of medical components together, but using adhesive tape is not acceptable for them. However, in the separate welding process, the cost wouldn not to much the cost... Should we invest in new equipment? But it is tough to invest only for this project.

It was a tough challenge... Give me just one week, and I will see if there is a better way. (With making a small modification on the existing equipment, I hope to handle continuous partial welding...)

(One week later)
Mr. President, please look at this! If we make a small modification to this part of the equipment, we can perform continuous partial welding. We can meet the cost requirements without investing in new equipment in this way!

Wow, that is an eye-opening idea! Let's modify the equipment and start prototyping immediately! Get it arranged right away!"

Through ingenuity and ideas like this, we were able to meet conditions that other companies said it was impossible.
This embodies our philosophy of "Challenge Spirit," the origin of our company name that keeping challenges.

See Case Studies of Processing

\ Quick Response! /Contact FormFor any inquiries or requests about processing of double or single sided tape or precision die-cutting of films, contact us from Contact Form below. We will get back to you shortly.

webmaster@cstec-jp.com

Contact Form